43
Tr
OUBLESHOOTING
Remove the battery and then install it again. Turn on the baby unit
and the parent unit. Allow up to one minute for the parent unit and
the baby unit to synchronise.
Other electronic products may cause interference with your video
and audio monitor. Try installing your video and audio monitor as far
away from these electronic devices as possible: wireless routers,
radios, cellular telephones, intercoms, room monitors, televisions,
personal computers, kitchen appliances and cordless telephones.
The
light and LOW BATTERY flash on the parent unit.
Charge the battery in the parent unit for up to 12 hours.
Remove the battery and then install it again. Use it until fully
depleted, then recharge it in the parent unit for up to 12 hours.
If the above measures do not correct the problem, replace the
battery.
The battery does not charge in the parent unit or the parent unit
battery does not accept charge.
Make sure the battery is installed in the parent unit battery
compartment correctly. The
light on the parent unit should be on
when charging.
Remove the battery and then install it again, then charge for up to
12 hours.
If the battery icon and the
light on the parent unit are not on,
refer to The
light on the parent unit is off below.
If the battery is completely depleted, it may take up to 30 minutes to
charge the parent unit before it can be used for a short time
(page 14).
Purchase a new battery. Refer to
parent Unit Battery Installation
(pages 11-12) and
parent Unit Battery Charging
(page 14).
The
light on the parent unit is off.
Make sure the parent unit battery is installed (pages 11-12) and
charged (page 14) correctly.
The
light is off when the battery is fully charged even if it is also
powered by AC power.
•
•
•
•
•
•
•
•
•
•
•
•
