Electronic switch 20A (opto)
www.VSpeak-modell.de
Page 3/4
4
LED-Display
4.1
internal green LED
OFF:
Switch is OFF
ON:
Switch is ON
Blinking:
Magnet near Sensor, switch status is kept on previous state
-or-
Fault, no servo signal for more than 2.5 seconds, switch is "OFF"
Flickering:
Programming mode (switch is "ON")
Single-Pulse: Mode1 „ON“
Double-Pulse: Mode2 „PWM-Mode“
4.2
external blue LED
OFF:
Load is switched "OFF", no connection to the load battery
ON:
Load is switched "ON", power from load battery
5
Technical data
Servo input
3,0 … max 15V
Switching voltage
3,0 … max 20V (3…13 Cells NiCd/NiMh, 1 to 4 Cells LiPo/LiFe)
Switch current
max 20 A
Power consumption
(control part, powered by the RX)
ON: about 13 mA
OFF: about. 4 mA
Power consumption
(switching part, powered by the
external battery)
ON: about 8 mA/ 2mA with / without external blue LED
OFF: ~
0 mA
(max 0,001 mA)
Mode 2, Pulsefrequency
~510 Hz
Size
30 x 9 x 8 mm (PCB)
Weight
6 g (incl. cable)
Connectors
RX cable (0,14 mm²)
red:
Battery-positive: 15cm Silicone cable (1,0 mm²)
black:
Battery-negative: 15cm Silicone cable (0,25 mm²)
yellow/red:
switched line
: 15cm Silicone cable (1,0 mm²)
2-pin socket for the external blue LED
The "ON" range can be programmed completely free.
