VS Sassoon VSM7473A, Руководство пользователя

Страница: 14 / 20

THE LITHIUM CUT / TOOL TIPS
14
CLIPPER CLEANING &
MAINTENANCE
Because the clipper blades are precision made for a very special use, they
should always be handled with care. To ensure long-lasting performance of your
clipper, it is important to clean the the comb guides after every use.
After each use, clean the clipper blade set as follows:
1. Switch the clipper off or unplug from the power outlet if it is charging.
2. Using the cleaning brush, gently brush and blow any hairs from the blade set
and head of your clipper.
3. Remove the blades carefully noting which way round they are fitted. This will
help with re-assembling.
4. Remove the two screws from the large fixed blade and detach this blade.
5. Now brush away the hair and other debris from the interior of the cutting
head and blades.
6. Re-assembly is simply the reverse of the above instructions.
7. Finally, before fully tightening the two screws in the large blade, to avoid
injury ensure that the blades are correctly aligned. With the taper control
lever fully forward, the tips of the small blade must be parallel with and
1mm below the tips of the large blade. Also check that the extreme left hand
tooth of the small blade is inside the large blade. (Failure to do so could
cause injury).
8. Carefully tighten the two screws in the big blade, taking care not to disturb
the above correct position of the blades
9. After replacing the blade set, always remember to oil the blade of your
clipper.
NOTE: Do not attempt to repair or replace the blades. In the event that the
blades become blunt or damaged, contact the Conair Customer Service.