USING THE COMB GUIDES
IMPORTANT:
Always attach the comb guide BEFORE turning the
clipper on. The contour following comb guide assists in creating an
even cutting result.
To attach a comb guide
, fi rst wind the rotary control (thumb wheel)
downwards, until it cannot be pushed down any further. Align the
comb guide by lining up the long sides of the guide with the sides
of the clipper. Insert side of guide into clipper and push down until
it ‘clicks’ into place.
To remove comb guide
, fi rst wind the rotary
control (thumb wheel) downwards, until it cannot
be pushed down any further. Turn clipper so that
the underside (back of unit) is facing towards you.
Holding the clipper with two hands, place thumbs
underneath the bottom of the comb guide and
push up until the guide ‘clicks’ out of position.
Telescopic comb guides (3mm to 30mm)
The I-clip features 2 telescopic comb guides with 18 precise length
settings (Comb guide grades #1-10) eliminating the need changing
and storing traditional comb guides.
Telescopic comb guide for shorter styles (3mm – 15mm)
Attach the comb guide as per instructions “Using the comb guides”
Use the rotary control (thumb wheel) to position the comb guide to
the required length.
Check the length setting (in mm) of your haircut through the
viewing window on the left side of the comb guide.
To remove the comb guide refer to “Using the comb guides”
Telescopic comb guide for longer styles (18mm – 30mm)
Attach the comb guide as per instructions “Using the comb
guides”
Use the rotary control (thumb wheel) to position the comb guide to
the required length.
Check the length setting (in mm) of your haircut through the
viewing window on the right side of the comb guide.
To remove the comb guide refer to “Using the comb guides”
Cutting Length
Comb Guide
3mm #1
6mm
#2
9mm
#3
12mm
#4
15mm
#5
18mm
#6
21mm
#7
24mm
#8
27mm
#9
30mm
#10
Precision comb guide (0.5 to 2.5mm)
The precision guide is designed for ultra close cutting length ideal
for creating designer stubble or close cropped hair styles.
This comb is adjusted manually.
To adjust the length setting, slide the switch located on top of the
comb guide.
5 length settings are shown on the top of the comb guide.
VS7920A_NEW4.indd 8-9
VS7920A_NEW4.indd 8-9
10/17/08 9:34:12 AM
10/17/08 9:34:12 AM
