Service
Vossloh-Schwabe Deutschland GmbH
Wasenstraße 25
D-73660 Urbach, Germany
Phone: +49 (0)7181 8002-0
For further information please visit our website: www.vossloh-schwabe.com
ENGLISH
EN
Safety notes
!
The Blu2Light products may only be installed and commissioned by authorised specialists. Read
these instructions carefully before installing and commissioning the system. This is the only way to
ensure safe and correct handling. Keep this manual in a safe place so that it may be available at a
later date. Before any work is carried out on the equipment, it must be disconnected from the supply
voltage. The applicable safety and accident prevention regulations must be observed. Improper
opening of the products is not permitted, there is a danger to life due to electrical voltage. Repairs
may only be carried out by the manufacturer. In the event of incorrect connection or reverse polarity,
the device and the connected LEDs may be damaged or destroyed!
Bluetooth
®
wireless technology
The Bluetooth® word mark and logos are registered trademarks owned by the Bluetooth
SIG, Inc. and any use of such marks by Vossloh-Schwabe is under license. Other trademarks
and trade names are those of their respective owners. We, Vossloh-Schwabe Deutschland GmbH,
hereby confirm that these devices only comply with the basic requirements of Directive 2014/53/ EU
and other relevant directives when used with Vossloh-Schwabe power supply EDXe 1120/24.060
(Ref. No.: 186627). The entire text of the declaration of conformity can be obtained from the following
addres
s
: www.vossloh-schwabe.com
Assembly
•
The Blu2Light driver is intended to operate LED luminaires (e.g. flat panels).
•
First connect the luminaires (e.g. flat panels) to the outputs of the drivers (sec.) to.
• Then connect the power supply to the module.
• The input side must be connected to mains voltage, 220-230 V AC or 176-276 V DC.
Installation instructions
• Pay attention to the correct polarity at the output: + and –
Setup and operation
•
The Blu2Light devices are configured with the LiNA Connect app and can be operated via the
LiNA Touch app.
•
For the exact procedure for the configuration of the devices please refer to the instructions in the
LiNA Connect app or in the corresponding documentation.
• A tablet is required for setup, both tablets and smartphones can be used for operation. Both are
not included in the scope of delivery.
App operating mode and operating devices
LiNA Connect configuration
iOS
Tablet
Version 10 and higher
LiNA Touch operation
iOS
Android
Tablet
Version 10 and higher
Version 5.0
Smartphone
Version 10 and higher
Version 5.0
Technical Notes
Ref.-No. Blu2Light PrimeLine DIP switch C loop: 187042
Communication: Blu2Light mesh network
Frequency range: 2402–2480 MHz
Output power: < 10 mW EIRP
Mains voltage: 220–240 V AC / 176–276 V DC
Power consumption stand-by / operation: 0.4 W
Ambient temperature ta: -25–50 °C
Protection class: IP20
Protection class II
Dimensions with cord grip: 141.6 x 79 x 30 mm (LxWxH)
Housing: plastics, white
Weight: 185 g
Push-in terminals for cross section: primary 0.75 mm² / secondary: 0.5–1.5 mm²
Min. dim level: 0.5 % from the maximum current (analog)
607447-00V1
Schaltbild / Wiring diagram
