VRmagic Eyesi, Инструкция по установке и эксплуатации, Страница: 24 / 80

5. Plug the USB cable coming from the monitor arm into the USB port on the
front side of the simulator PC (
Â
Fig. 5 on page 21).
6. Plug the audio cable into the audio jack (
Â
Fig. 5 on page 21).
7. Properly align the DVI plug coming from the monitor arm with the DVI port and
carefully plug it in (
Â
Fig. 5 on page 21). Tighten both screws on the plug by
hand to ensure it is firmly connected.
8. Properly align the VRx power plug with the touch screen power outlet of the
simulator PC (
Â
Fig. 5 on page 21). The red dot on the power plug must be
in 3 o’clock position as indicated in
Â
Fig. 11 on page 24.
90°
Fig. 11: Connecting the VRx power plug
9. Carefully push the power plug into the power outlet.
4.6 Attaching and Connecting the Touch Screen
After the monitor arm has been securely attached and all cables have been con-
nected to the simulator PC, you can place the touch screen on the monitor arm.
NOTICE
Touch screen may fall down during assembly
The touch screen is not screwed onto the monitor arm and is not secured
against removal. This may cause it to fall down, e.g. when connecting the
cables.
f
Make sure to hold the touch screen whenever necessary during the re-
maining assembly steps so that it cannot fall down or otherwise become
damaged.
f Make sure that the monitor arm has been securely mounted to the
mounting receptacle before attaching the touch screen (
Â
section 4.5 on
page 23).
Eyesi Surgical Simulator – Installation and Operating Guide
24
Installation