................2
....................1
2mm
Triple connector
.......3
2x950mm rod
Steel clevis
.......3
(2 x120mm) rod
............2
(1.2 x500mm) throttle rod
............1
2 mm
Throttle servo
Throttle push-rod
In case of Glow engine using
1.2x500mm
X
Rudder push-rod
2x950mm
3mm set Screw
2 mm
Tail gear push-rod 1.2x800mm
Cut the rudder push-rod excess length.
Cut the tail wheel push-rod excess length.
Insert all into the triple connector and tighten everything.
Triple connector
Do the same way with the elevator linkages.
Insert the rudder push-rod from the rear of the fuselage.
Screw the clevis mid-thread, then connect to the rudder
control horn.
Elevator servo
Rudder servo
Throtlle servo
Insert the
two
elevator
push-rod from the rear of the fuselage.
Screw the clevis mid-thread, then connect to the
elevator
control horn.
FUELAGE BOTTOM-VIEW
18- SERVO AND LINKAGES
P-47 THUNDERBOLT
