X
To muffler
Filler tube
To engine
3x25mm
screw
Rubber stopper
1
After confirming the direction . Insert this assembly,
clunk end first, into the fuel tank and tighten and
screw the fuel tank cap on firmly.
3x25 mm screw
11/64”(4mm)
2
19- Fuel tank installation / Tankeinbau
2.5x10mm.....4
1~2mm
Attach the board or transparent plastic on the side of
the fuselage with the adhesive tape as show.
Using a pencil or felt tipped pen trace around the engine
head where it meet the cowl. Cut the opening the board
or transparent plastic for the engine head as marked
above.
Remove the engine and insert the cowl on to the fuselage
so the distance from the fire wall to the front of the cowl is
4-33/64” to 4-41/64” (114 to 117mm) .
Remove the cowl from the fuselage and carefully cut the
opening for the engine head as marked above. Do the
same way with the hole for needle-valve.
Again. Insert the cowl on to the fuselage and secure it in
place with five 2x5mm screws.
114mm
Ruler
Board
Adhesive
tape
1.5mm
1/16”
1.5mm
1/16”
20- Cowling installation / Motorhaube
Magnetic battery hatch
Battery stand (3mm ply)
(In case of Electric power)
In case of gas engine
Secure the battery stand
in place using CA glue