CA
Cut away only the film
Cut away only
the film
Using the aileron servo tray as a template,
trace around the outside edge of the aileron
servo tray and then remove it.
Using a sharp hobby knife, cut away the
covering inside the lines. Not to cut into the
wood.
Apply the aileron servo tray in place and
secure the servo tray with CA glue.
Aileron servo tray (Ply wood)
2- Aileron servo tray
X
X
Included with the radio set.
Aileron servo
Retract landing gear
servo
1.2mm
3- Servos installation
A B
L/R
A B
! Make sure to glue
securely, If not properly
glued, a failure in flight may
occur.
Trial fit each part before gluing . Be certain
that there are no gaps. If the parts will join,
but with a gaps, sand or trim the parts a little
at a time until the parts meet exactly with no
gaps.
Check for the correct dihedral angle
Carefully slide the wing halves together, ensuring that they are accurately aligned, Firmly press the two
halves together, allowing the excess epoxy run out. Using rubbing alcohol and paper towel, clean off
the excess epoxy.
When joining the wing halves it is extremely important to use plenty of epoxy (30 minutes epoxy).
1- Joining the wing
Use epoxy glue to bury the opening
