Awl
.........................................................
.........................................................
.........................................................
.........................................................
.........................................................
.........................................................
.........................................................
.........................................................
.........................................................
.........................................................
.........................................................
SILICON
EPOXY A
EPOXY B
CA
Silicon sealer
Silicone tube
Extension for aileron servo.
Read through the manual before you begin, so you will have an overall idea of what to do.
Brushless Motor
600-720W
or equivalent.
LiPo 4500 mAh (5-6)S
REQUIRED FOR OPERATION
(
Purchase separetely
)
10.5x6 for .40 - 2 cycle engine
11x6 for .46 - 2 cycle engine
11x7 for .52 - 4 cycle engine
12x7 ~13x6 - Electric motor
.40 - .46 - 2T
.52 - .70 4T
Radio a 5 channel (min)
4 servo (Motorx1, Rudderx1
Elevatorx1, Aileronx2: mini
or standard servo.
GLUE
(Purchase)
Cyanoacrylate
Glue
Epoxy glue (5 minute type)
Epoxy glue (30 minute type)
TOOL REQUIRED
Hobby knife
Needle nose Plier
Sander
Phillip screw driver
Scissor
Hex Wrench
Wire Cutters
Masking tape - Straight Edged Ruler - Drill and Assorted Drill Bits
TABELLA DI CONVERSIONE
1.0mm = 3/64”
1.5mm = 1/16”
2.0mm = 5/64”
2.5mm = 3/32”
3.0mm = 1/8”
4.0mm = 5/32”
5.0mm = 13/64”
6.0mm = 15/64”
10mm = 13/32”
12mm = 15/32”
15mm = 19/32”
20mm = 51/64”
25mm = 1”
30mm = 1-3/16”
45mm = 1-51/64”
If exposed to direct sunlight and / or heat, wrinkles can appear. Storing the model in a coll
place will let the wrinkles disappear. Otherwise, remove wrinkles in covering film with a hair-
dryer, starting with low temperature. You can fix the corners by using a hot iron.
1.5mm
A B
!
CA
L/R
Assemble left and right
sides the same way.
X
Drill holes using the stated
size of drill
(in this case 1.5 mm Ø)
Use epoxy glue
Take particular care here
Hatched-in areas:
remove covering
film carefully
Not included.
These parts must be
purchased separately
Check during assembly that these
parts move freely, without binding
Apply cyano glue