1- Joining the wing
1- Using a pencil, mark the center of the brace.
2- Trial fit the wing joiner into one of the wing panels. It should
insert smoothly up to the center line marked above.
3- Slide the other wing half onto the dihedral brace until
the wing panel meet. If the fit is over tight, it may be
necessary to lightly sand the dihedral brace.
4- Check for the correct dihedral angle.
5- Mix approximately 30 minute epoxy and apply a generous amount of epoxy into the wing joiner cavity of one wing half.
6- Coat one half of the dihedral brace with epoxy up to the center line. Install the epoxy-coated side of the dihedral brace
into the wing joiner cavity up to the center line, marking sure that the “V” of the dihedral brace is positioned correctly
7- Do the same way with the other wing half.
8- Carefully slide the wing halves together, ensuring that they are accurately aligned. Firmly press the two halves
together, allowing the excess epoxy to run out. Clear off the excess epoxy.
Center line
TOP-VIEW
Cut away only
the film
2- Retract servo mount
TOP-VIEW
A
B
C
B
C
A
CENTER
WING
SECTION
CA
CA
CA
CA
BOTTOM
Retract servo tray
Retract servo mount
Retract servo mount “B”is longer than “C”
Note:
3- Retract servo
TOP-VIEW
CENTER
WING
SECTION
BOTTOM
Retract servo
Retract servo
X
Install the retract servo onto the retract
servo mount and secure it in place with
four screw (included with radio set).
Note: The head of servo should be positioned
toward the rear of the wing.
RETRACT SERVO INSTALLATION
