Ju-52 version Olympiade 1936 decal
Lufthansa decal
Note: Cut out the stickers and apply them in the proper area. Do not peel the backing paper off all at once.
Peel off one corner of the backing and cut off with scissors.
Arrange sticker on model and when satisfied adhere the corner without backing.
Carefully peel back the rest of the backing while at the same time adhering the rest of the sticker.
Try not to make air bubbles, if there are some, carefully puncture sticker (center of bubble) but not model
surface with the tip of the knife or sharp pin and squeeze out the air.
Cut around the cycles
Wing center section
DO NOT try to fly an out-of-balance model !
Note: If necessary, move the battery pack or add weight to either
the tail or nose until the correct balance is achieved.
10mm Up
25 mm
RUDDER
6mm
AILERON
IMPORTANT: Flying your model at these throws will provide you with the greatest chance for successful first flights.
If,after you have become accustomed to the way the Ju-52 flies, you would like to change the throws to suit your taste
that is fine. However, too much control throw could make the model difficult to control, so remember, “more is not always
better”.
ELEVATOR
20mm
FLAP
88~94mm
IMPORTANT:
Please do not clean your model with pure alcohol, only use liquid soap with water or use glass cleaner
to clean on surface of your model to keep the colour not fade.
BALANCE - CONTROL SURFACE
6mm
25 mm
8mm Down
19
20
Decal for recover
