2
NOT FOLLOWING THIS MANUAL WILL VOID YOUR WARRANTEE.
FAILURE TO SEND IN THE WARRANTEE CARD WILL VOID YOUR WARRANTEE
Be very careful when handling the tone arm. The internal arm wire is exposed at the
headshell and at the rear of the arm. This wire is
very
delicate and contains 64 strands
of very pure copper. Physical damage to the wire is not covered by the warranty after
the arm is removed from its box.
The bearing point is very sharp, be careful.
There are a number of setscrews on the JMW Memorial Tone Arm. The Allen
wrenches that come with your arm will only fit the setscrews that you will need to adjust.
All other screws are factory set and should not be adjusted, except by our trained
technicians. Resetting any of the factory settings is not covered by the warranty.
DO NOT PUT THE DAMPING FLUID IN THE ARM UNTIL YOU
ARE FINISHED WITH ALL THE ADJUSTMENTS
CARTRIDGE MOUNTING:
FOR CARTRIDGES WITH THREADED MOUNTING HOLES:
Use the screws supplied
by the cartridge manufacturer to mount the cartridge. Any other screws may not fit the
thread properly and may even damage the threads and cartridge. USE ONE OF THE
SUPPLIED WASHERS UNDER THE SCREW HEAD.
FOR ALL CARTRIDGES WITH PASS THROUGH MOUNTING HOLES:
Use the
hardware supplied with the arm. Remember to use the washers under the screw
heads to prevent damage to the finish on the JMW arm.
In this step, the connectors will be attached to the cartridge's terminals.
The color code of the
wires
is as follows:
RED = right hot WHITE = left hot
GREEN = right ground BLUE = left ground
IF YOUR PHONO SECTION INVERTS PHASE, THE HOT BECOMES
THE GROUND COLOR
Using tweezers or fine tipped pliers grip the center of the red wire's connector (do not
grip the wire) and push it onto the cartridge’s right hot terminal pin. In the same way,
connect each of the remaining
connectors to its respective cartridge terminal. Do not
AllegroSound.com
Содержание JMW 10
Страница 9: ......
