48
How to configure the weighing options
1. Tap the toggle mode button to open the gross display mode
2. Tap the cycle button until the configuration option is highlighted
3. Tap the select button to open the configuration menu
If multiple junction boxes are connected to the system, you are prompted to select a junction box.
Select the junction box you want to apply any relevant changes to.
4. Tap the scroll up or scroll down buttons until the weighing config option is highlighted
5. Tap the select button to open the weighing config menu
Power on screen
The power on screen is displayed when you power on the display unit. By default, this is the axle display
mode.
The power on screen can be set to show either the axle display mode or the gross display mode when
the display unit is powered on.
A
G
A
G
A
G
A
G
Weighing Config.
System Config.
Vehicle Config.
Calibration
Alarms
Configuration
TruckWeigh
®
Содержание TruckWeigh
