9050 USER MANUAL
VPC
07/19/2022
For more information visit vpc.com
4
Figure B.
Figure D.
Do not initially tighten down the 4 front and 4 rear
mounting screws on each tier of slides.
INSTALLING 9050TR WITH SLIDE KIT
PART # 310 104 369, 310 113 451, 310 113 411, 310 113 500
Dimensions shown: [millimeters]
inches
TOOLS REQUIRED
Phillips Head Screwdriver
³/
32
Allen Wrench
DETERMINE SLIDE KIT LENGTH
1.
The slide kit should be chosen based on the distance from rail to rail inside the
rack. Measure dimension A to determine the proper slide kit length, ensuring
the slide length does not exceed dimensions A + B (
Figure B
).
SLIDE INSTALLATION
1.
The height and weight of the 9050 and 9050TR require the use of 2 sets of
slides for full support. Determine the desired approximate rack location
to mount receiver and platform. The 9050TR (p/n 310104369) includes 2
instrument brackets, one for each tier, that can support a test chassis for
close proximity access (
Figure A
). Keep in mind when selecting a receiver
location that any system cables will need to be long enough to connect to
instrumentation and allow for slides to fully extend without putting tension
on the cables.
2.
Install both sets of slides using manufacturer’s instructions (included with
slide packaging or online at accuride.com). A distance of 9.870 [250.70] is
required from the top rear screw hole of the top set of slides to the top rear
screw hole of the bottom set of slides (
Figure C
).
3.
Make sure to horizontally match the location of the rack mounting holes
used for each tier of slides. Do not fully tighten down the 4 front and 4 rear
mounting screws at this time, on each tier of slides (
Figure D
).
Figure A.
Each set of slides supports an instrument bracket (shelf)
for easy test chassis access.
Figure C.
9050TR side profile view. Measurements for vertical
distance between slides. See product drawing for p/n 310104369 for
more detail (available at vpc.com).
[190.06]
7.48
[250.70]
9.87
[31.75]
1.25
PLATFORM
RECEIVER
FRONT
INSIDE RACK
10-32
MOUNTING
SCREWS-
4 x FRONT &
4 x BACK
MOUNTING
HOLE
LOCATIONS
MATCH
HORIZONTALLY
NOTE:
The receiver platform is estimated to hold 180 lbs of weight.
However, the platform leg kit, is recommended to provide greater
stability and balance. The leg kit will allow for weight support of up to
350 lbs. The leg kit may be purchased via
.