INSTALLATION INSTRUCTIONS
BEFORE YOU BEGIN INSTALLATION:
Before drilling, be sure that no cable or wiring is on the other side. Clamp all wires
securely to reduce the possibility of them being damaged during installation and use.
Keep all cables away from hot or moving parts, and electrically noisy components.
Wiring Definitions:
¡
Power connection:
Pin 1
ACC +12V (Red)
Pin 2
Standby Reverse Trigger (Blue wire)
Pin 3
Ground (Black wire)
Pin 4
Audio Trigger (White wire)
Pin 5 Standby Left Trigger (Brown wire)
Pin 6 Standby Right Trigger (Green wire)
¡
Camera A input:
Connection for camera or camera extension cable
¡
Camera B input:
Connection for camera or camera extension cable
¡
Camera C input:
Connection for camera or camera extension cable
¡
LCD panel:
13-pin DIN cable connection: junction box to monitor.
Procedure:
1. Choose the monitor, junction box, and camera mounting locations.
2. Install all required cables in vehicle. A ¾” (19mm) hole should be drilled for
passing cables through vehicle walls, barriers, etc. After the intermediate cable is
passed through the hole, install the split grommet (included). If additional cable
protection is required install convoluted tubing over the cable.
3. After cable/wiring has been routed and components are in place, temporarily make
all system connections and perform a system function check. If system does not
operate properly, see the troubleshooting section of this manual.
4. If using an optional PanaVise
®
stalk mount (available separately), use the
mounting template provided on page 11. Install the PanaVise
®
mount to the LCD
monitor using the #10 self-drilling screws (included).
**Important: Do not use screws other than those provided with the AOM703.
Void of warranty and serious product damage will occur.
6
