128-9307
14 of 16
Page 14
To purchase replacement transmitters
or to get additional product information go to:
www.pursuitcarsecurity.com
NOTE:
Certain systems have the ability to utilize channels 6 and 7 for driver priority
programming. For driver priority, the vehicle must be equipped with this fea-
ture, and the optional feature must be set up and installed by your installation
center. Once this feature is added when the unlock button of transmitter 1 is
used, it will set driver 1 priority and when the unlock button of transmitter 2
is used it will set driver 2 priority. In this situation, the unlock button can be
programmed into two receiver channels, unlock, channel 2 and driver priority
6 or 7. In no other circumstance will the system allow a transmitter button
to be programmed into 2 receiver channels at the same time.
This remote has the ability to operate 2 similar Alarms From A Single Transmitter.
To toggle on and off vehicle one or two:
Press the Trunk/Key the Lock button for 5 seconds.
The LED flashes 2 times. Release the buttons, to select 2nd vehicle mode.
Program this transmitter into the second vehicle's system. Any time you are in 2nd
vehicle when the transmitter is operated, the LED will flash twice for each function.
When in the prime vehicle mode, the LED will flash once for each function.
Transmitter Battery Replacement
1) Remove the 00 Phillips head screw from the rear case.
2) Separate the case halves by inserting a small plastic tool in the top right slot.
3) Carefully slide the CR2032 battery out from under the battery clip and dispose
of properly.
4) Insert a fresh CR2032 battery with the (+) side up away from the PCB.
5) Close the case in reverse of disassembly.
FCC COMPLIANCE
This device complies with Part 15 of the FCC rules and with RSS-210 of Industry Canada.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including any interference that may
cause undesired operation.
Warning!
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment
NOTE: The manufacturer is not responsible for any radio or TV interference caused by
unauthorized modifications to this equipment. Such modifications could void the user’s
authority to operate the equipment
