Installation
License Plate Mounting
1. Remove the rear license plate.
2. Examine the vehicle to determine the best way to run the power
wires to the reverse lights and the extension cable through the
car.
3. The Camera can be mounted above or below the plate. (For
surface mounting with the included bracket, see the next
section.) Determine the mounting location that best suits your
needs. Be sure to verify that the installation plan complies
with local laws and requirements. Most states require that the
state name, registration stickers, and license number are not
obstructed in any way.
4. Place the camera bracket behind the license plate and line up
the holes. Fasten the camera mounting bracket and the license
plate to the vehicle using the anti-theft screws provided. After
installation of screws with the tool provided, place the tool in the
glove compartment or other safe place for future use.
NOTE:
If you decide to mount the camera at the bottom of the
license plate, you must first remove the screw that holds the
camera to the bracket and flip the camera over so the picture will
not be displayed up side down.
