18
ENGLISH
1. Remove the main unit with the packing from the box and remove the packing.
2. Set the 45-RPM adaptor on the main unit.
3. Set the turntable platter onto the center spindle.
4. Set the slip mat on the platter.
5. Installation of cartridge:
When installing a cartridge, refer to the operating instructions of that cartridge.
During installation, attach the stylus protector to guard the stylus tip from damage.
(a) Connect the lead wires to the cartridge terminals. The terminals of most cartridges are color-coded.
Connect each lead wire to the terminal of the same color.
White (L+) ............................................ Left
Blue (L-) ............................................... Left channel-
Red (R+) ............................................. Right
Green (R-) ........................................... Right channel-
(b) Install the cartridge to the headshell and tighten it with screws provided with the cartridge.
6. Insert the headshell into the front end of the tone arm, then turn the lock nut counterclockwise with the headshell
fi rmly held horizontally.
7. Slide counterweight onto tone arm. Twist it lightly and it will screw onto the rear shaft of the tone arm.
8. Adjustment of horizontal “zero” balance and stylus pressure:
(a) Remove the stylus protector from the headshell, do not touch the stylus tip during the adjustment.
(b) Set the cueing lever to the lowered position.
(c) Release the tone arm clamp and lift the tone arm from the arm rest to free it.
(d) Rotate the counterweight until the tone arm is approximately balanced horizontally (fl oats freely).
(e) Refasten the tone arm with the tone arm clamp.
(f ) Hold the counterweight stationary with one hand and rotate only the stylus-pressure ring to bring the number
"0" of the ring into alignment with the center line on the tone arm rear shaft.
(g) Rotate the counterweight including the stylus-pressure ring counterclockwise until the scale shows the
value corresponding to the pressure of the stylus used. Should you use a separate Stylus, please follow the
manufacturer’s instructions.
9. Set the anti-skating control knob to the same value as the stylus pressure.
10. Install the dust cover to the main unit’s dust cover hinges.
NOTE
:
Do not remove the twist tie for clamping the tone arm until assembly is completed.
•
Do not connect the power supply cord until assembly is completed.
•
ASSEMBLY
HP-FU1000B (010615) .indd 章節2:18
HP-FU1000B (010615) .indd 章節2:18
2015/1/6 上午 08:21:42
2015/1/6 上午 08:21:42