VOX electronics EBI 200 DB, Руководство по эксплуатации

Страница: 16 / 129

EN - 15
Buzzer
While the hob is in operation, the following
activities will be signalled by the buzzer:
•
Normal button activation will be
accompanied with a short sound signal
•
Continuous button operation over a
longer period of time (10 seconds)
will be accompanied with a longer,
intermittent sound signal.
Boost Function
To use this function, a cooking zone must
be selected,with the desired cooking level
set. Then press the P(Boost) button.
The Boost function can only be activated
if it is applicable with the cooking zone
selected If Boost Function is active a ´
P
` is
shown on the corresponding display.
Activating the booster can exceed the
maximum power, in which case the
integrated power management will be
activated.
The necessary power reduction is shown
by the corresponding cooking zone display
blinking. Blinking is active for 3 seconds
and allows further adaptations of the
settings before power reduction.
Error Codes
If there is an error, an error code will be shown on the
heater displays.
E1
Cooling Fan is disabled. Call an authorised
service agent.
E3
Supply voltage is other than the rated values.
Turn the hob off by touching ,wait until “H”
disappears for all zones, turn the hob on by
touching and continue to use. If same error
is displayed again, call an authorised service
agent.
E4
Supply frequency is different from the rated
values. Turn the hob off by touching , wait
until “H” disappears from all zones, turn the
hob on by touching and continue to use. If
same error is displayed again, turn the plug
for the appliance off and on. Turn the hob on
by touching and continue to use. If same
error is still dispayed again, call authorised
service agents.
E5
Internal temperature of the hob is too high,
turn the hob off by touching let the heaters
cool down.
E6
Communication error between touch control
and heater. Call an authorised service agent.
E7
Coil temperature sensor is disabled. Call an
authorized service agent.
E8
Cooler temperature sensor is disabled. Call
an authorized service agent.
E9
Calibration error. Call authorised service
agent.
5. CLEANING AND
MAINTENANCE
5.1. Cleaning
WARNING:
Switch off the appliance
and allow it to cool down before
cleaning your appliance.
General Instructions
•
Check whether the cleaning materials
are appropriate and recommended by
the manufacturer before using on your
appliance.
•
Use cream cleaners or liquid cleaners
which do not contain particles. Do not
use caustic (corrosive) creams, abrasive
cleaning powders, rough wire wool or
hard tools as they may damage the
cooker surfaces.
•
Do not use cleaners that contain
particles, as they might scratch the
glass, enameled and/or painted
parts of your appliance.
•
Should any liquids overflow, clean them
up immediately to avoid parts becoming
damaged.
•
Do not use steam cleaners for
cleaning any part of the appliance.
Cleaning the Ceramic Glass
Ceramic glass can hold heavy utensils but
may be broken if it is hit with a sharp object.
WARNING:
Ceramic Cooktops - if the
surface is cracked, to avoid any
possibility of electric shock switch off
the appliance and call for service.
•
Use cream or liquid cleaner to clean
vitroceramic glass, then rinse and dry
them thoroughly with a dry cloth.
•
Do not use cleaning materials
meant for steel as they may
damage the glass.
•
Spilt sugary or sweet foods must be
cleaned immediately after the glass has
cooled down.
•
Dust on the surface must be cleaned
with a wet cloth.
•
Any changes in colour to the ceramic
glass does not affect the structure or