Vortice Deumido Electronic E10, Инструкция пользователя

Страница: 17 / 118

17
OPERATION
A
3
Insert the plug in the socket - electrical
specifications shown on the ID plate on the back
of the appliance (fig.A)
2 - Press “ON/OFF” to turn the appliance ON. The
compressor will start to operate in continuous
mode.
3 - Press “HUM” to select the type of
dehumidification required: continuous
dehumidification, 50%, 60%, 70% or 80%.
4 - Press SPEED to select the required fan speed
setting.
5 - Press TIMER to select how long you want the
appliance to run for.
6 - Press “TEMP” to display the temperature.
7 - Press ON/OFF once more to switch the appliance
OFF.
Removing condensation.
When the tank is full, the compressor stops
automatically and the “Tank full” light goes red.
In this case:
- Press “ON/OFF”
- Remove the tank pulling it by the handle.
- Empty the tank then carefully reposition it.
- The tank is properly positioned if the “Tank Full”
light goes out.
N.B. If the tank has not been correctly repositioned,
the level indicator will go red again.
Continuous condensation drainage.
If the dehumidifier is used in a very damp
atmosphere, the tank will need to be emptied more
often. Under such circumstances, it can be more
convenient to organise continuous drainage by
means of the following procedure:
• Remove the grommet from drainage hole “A” at
the back of the appliance and connect a 12mm
drainage hose to the appliance (Fig.3).
N.B. The drainage hose does not come supplied
with the appliance.
• Remove the condensation collection tank. Take the
grommet from hole “A” and fit it to hole “B” (Fig.4).
• Make sure that the condensation drains away
freely and that the hose is properly fixed in
position.
• Replace the condensation collection tank in its
position (Fig. 5)
• To prevent leaks, position the tank as shown in figure
6.
N.B. If the appliance is operating in very cold
surroundings, take precautions to prevent it from
freezing.
N.B. If the power supply is cut off during operation in
TIMER mode, when power is restored the timer will
be reactivated, taking account of the time elapsed
before the power failure.
E.g. if the original Timer was set to 4 hours and the
power supply was cut off after it had been operating
for 2 hours, when power is restored to the appliance
it will operate for the remaining 2 hours and not the
original 4-hour period; only whole hours will be taken
into account at the restart, e.g. if the original setting
was 4 hours and the power supply was cut off after 2
and a half hours, when power is restored the
remaining operating time will be 2 hours.
If the Control Panel is switched off, however, any
Timer settings at that moment will be reset.