STRIKE EAGLE
®
6
7
You may notice that on 1x you have to make an
additional adjustment to the Fast-Focus Eyepiece
to achieve a flat field of view. This is specific to all
1x optics.
Adjusting the Fast-Focus Eyepiece for the Flattest Field
of View on 1x:
• Turn the magnification ring to 1x. While looking
at an object about 25 yards away, taking short
glances through the optic, turn the Fast-Focus
Eyepiece clockwise, until the image is true 1x.
The object should appear the same size through
the optic as it does to your naked eye. This may
take several attempts.
Note: This will be a target-dependent adjustment for close range
shooting and may cause the reticle to appear slightly out of
focus on the highest power.
Once this adjustment is complete, it will not be
necessary to refocus every time you use the riflescope.
However, because your eyesight may change over time,
you should recheck this adjustment periodically.
Parallax
The Strike Eagle
®
1-8x24 FFP comes equipped
with a fixed parallax setting at 125 yds. There is no
adjustment on this model.
Magnification Adjustment
The magnification
adjustment is used to
change the riflescope’s
“power.” The Strike
Eagle
®
1-8x24 FFP is a
variable powered optic
with an 8x optical
design. This will allow you to change the power from
1x to 8x using the Magnification Adjustment Ring.
To adjust your optic’s magnification, rotate the
Magnification Adjustment Ring clockwise, or
counterclockwise, to increase or decrease the
magnification to your desired level.
Throw Lever
Make magnification
adjustments smooth and
easy by attaching the
included Throw Lever.
Installation
1. Find the center of travel on your riflescope’s
Magnification Adjustment Ring. This should ensure
that the Throw Lever does not contact anything on
the rifle.
2. Gently spread the ring enough to get it over
the eyepiece.
3. Slide the Throw Lever onto the magnification ring at
the desired position.
4. Insert the hex screw through the unthreaded hole
in the lever and into the ring and tighten only
until snug and the ring does not slip when rotated.
If you use a torque wrench, tighten to 2.2 inch-
pounds (in.lbs.).
5. Test to ensure the Throw Lever is in the best
position for you. To adjust, simply loosen
the screw and reposition the lever to a more
comfortable position. Then, retighten the screw
and test the new position.
Throw Lever
