11
7) Attach the end of the next Runway Section (2) labeled B2 to the previously assembled runway
sections. Insert the hardware through the side rails of the assembly as shown in Figure 10, Detail A.
The required hardware is as follows: 3/8”-16 x 4” Button Head Cap Screw S/S (11), 3/8” Flat Washer
S/S (24), 3/8” Flat Washer S/S (24), 3/8” Lock Washer S/S (25), 3/8” Hex Nut S/S (26).
Next, attach the runway parts to the 2
nd
branch arm as shown in Figure 10, Detail B. The hardware
required for this step is as follows: 3/8” X 5.5” Hex Bolt(8), 3/8” Flat Washer (21), 3/8” Nylon Washer
(23), 3/8” Flat Washer (21), 3/8” Lock Washer (25), and a 3/8” Hex Nut (26). It is important that the
Nylon Washer (23) be placed against the metal branch arm bracket.
This process should be repeated for the three remaining Runway Sections. Remember that order
of assembly is important. The end of each runway section is labeled and must be assembled to the
runway section with the same number.
Note: Be sure to apply anti-seize to all fasteners to prevent galling
Assembly Tip: Irwin Quick Grip bar clamps may be used to help align the fastener holes in
the runway sections.
JOINT B1
JOINT B2
JOINT B3
FIGURE 10
(8)
(21)
(23)
(25)
(26)
(24)
(11)
(25)
(26)
Содержание S.R.Smith
Страница 4: ...4 VORTEX SLIDE WITH STAIRS LAYOUT FIGURE 1 ...
Страница 5: ...5 VORTEX SLIDE WITH LADDER LAYOUT FIGURE 2 ...
Страница 32: ...32 FIGURE 27 ...
