Vortex 851R, Руководство пользователя, Страница: 86 / 146

-86-
18.
Tilt the top of the printhead cartridge toward the back of the printer, about 20º.
19.
Gently seat the back of the printhead cartridge into the print engine.
20. When the back of the printhead is firmly seated, gently rotate the printhead
cartridge into position against the stops on the printhead connector board until it
clicks into place.
CAUTION
If the printhead will not rotate into position, do not force it!
21.
Slowly close the printhead latch. The fluidic couplings will advance and seal to the
printhead cartridge.
22.
Close the printhead latch. When the printhead latch is closed, the printer will prime,
clean and cap the printhead automatically. This operation will generally take a
minute or two, and will be apparent from sounds emanating from the print engine. If
the engine don’t start it automaticaly, then open the toolbox and press thesystem
prime.
23. When the system is primed, print a test printjob from Toolbox to make sure the
cleaning process was right and the printhead is working properly.
Picture of PH alignment pin interface
Alignment Pin
PH Groove