17
WWW.VORONDESIGN.COM
TOOLS
SOLDERING IRON
We use this for setting heat-set inserts into
parts. Depending on your sensor choice,
you might be soldering some wires
together.
ANGLE GRINDER/DREMEL
If you can’t find a pre-cut 50 mm MGN9
rail, you’ll need to cut down a longer one.
Leave your grandfather’s trusty hacksaw
in the toolbox: rails are usually hardened
steel.
VISE
A vise is handy if you have to cut your
MGN9 rail. A vise may also be helpful
when putting magnets in their holders.
WIRING CRIMPER
You’ll need this to wire up the sensor.
Or maybe theres a turnkey solution out
there you can buy, check Discord. If you
got this far without learning how to crimp,
we don’t judge.
SUPERGLUE
Yes, we consider this a tool. Superglue is
useful as a plastic safe threadlock, and
magnet glue. Cheap, single-use gel tubes
are fine.
PRINTED CUT GUIDE
If you have to cut your MGN9 yourself,
this can help you mark the places to cut.
Remove the tool before cutting, or you
will melt it to the rail.
MGN9 ASSEMBLY TOOL
We love this thing. Print it. You will need
it.
Marvel at its simplicity and wonder why
you never thought of it before.
