9
English
4.
Adjust to desired pole length and rotate collet thumb screw clockwise to
secure two poles together.
5.
Insert top of upper pole into recess on underside of yoke cap. Use hex
wrench to tighten set screw on back side of yoke cap.
6.
With circulator still resting on soft surface, insert lower pole into recess on
top of base. From underside of base, fully tighten thumb screw to secure.
7.
With one hand supporting circulator head and one hand on pole, lift
VFANSRP (VFAN SR Pedestal) upright.
To adjust height of circulator:
Note:
Before adjusting height, check that power cord is
not tangled and is able to move freely.
1.
Support circulator head with one hand. Use other hand
to loosen thumb screw.
2.
Adjust pole to desired height and secure into position
by fastening thumb screw.
Note:
After adjusting height, ensure that thumb screw is
fully tightened to ensure circulator head does not fall.
