VONROC IW503AC, Оригинальное руководство пользователя

Страница: 5 / 72

EN
5
WWW.VONROC.COM
if damaged by use of the tool. Use suitable de-
tectors to determine if there are hidden supply
lines or contact the local utility company for
assistance.
Electrical safety
Always check that the voltage of the power
supply corresponds to the voltage on the
rating plate.
If the supply cord of this power tool is damaged,
it must be replaced by a specially prepared supply
cord available through the service organization.
• Do not use the machine if the mains cable or
the mains plug is damaged.
• Only use extension cables that are suitable for
the power rating of the machine with a minimum
thickness of 1.5 mm
2
. If you use an extension
cable reel, always fully unroll the cable.
2. MACHINE INFORMATION
Intended use
The machine is intended for driving in and loose-
ning screws and bolts as well as for tightening and
loosening nuts whilst adhering to the technical
data. Main purpose environment is in the automo-
tive sector, for metal construction or roofing work.
The device is not intended for drilling.
TECHNICAL SPECIFICATIONS
Model No. IW503AC
Voltage 220-240V~
Frequency 50Hz
Rated input 450W
Protection class Class II
No load speed 0-3000/min
No load impact rate 0-4000/min
Chuck 1/2” square chuck
Max. torque 350Nm
Weight 2.2 kg
Sound pressure level L
PA
101.6 dB(A) K=3 dB(A)
Sound power level L
WA
112.6 dB(A), K=3 dB(A)
Vibration 19.433 m/s² K=1.5 m/s²
Vibration level
The vibration emission level stated in this instruction
manual has been measured in accordance with
a standardized test given in EN 62841-1 and EN
62841-2-2; it may be used to compare one tool
with another and as a preliminary assessment of
exposure to vibration when using the tool for the
applications mentioned.
• Using the tool for different applications, or with
different or poorly maintained accessories, may
significantly increase the exposure level.
• The times when the tool is switched off or when
it is running but not actually doing the job, may
significantly reduce the exposure level.
• The vibration emission during actual use of the
power tool can differ from the declared total value
depending on the ways in which the tool is used.
• Need to identify safety measures to protect the
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when
it is running idle in addition to the trigger time).
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm, and organizing your work patterns.
DESCRIPTION
The numbers in the text refer to the diagrams on
page 2.
1. Machine
2. Main handle
3. Power cable
4. On / off switch
5. Direction switch
6. 1/2” (12.7 mm) square chuck
3. ASSEMBLY
Before assembly, always switch off the
machine and remove the mains plug from
the mains.
Removing and mounting accessories
Use only 1/2” (12.7 mm) impact accessories.
Non-impact accessories may break and
cause a hazardous condition. Inspect
accessory prior to use to ensure that it
contains no cracks.