VonHaus 3500060, Инструкция по эксплуатации

Страница: 6 / 10

To assemble the Ash Vacuum, insert the screw end of the
Flexible Hose
(3)
into the Vacuum Inlet
(10).
To insert,
align the notches and twist to secure into position Fig 1.
NOTE:
If the area you are to vacuum contains large pieces
of debris it is advised you attach the Debris Filter (1) to
avoid clogging up the Vacuum.
To use the Debris Filter, loosen the screw and slide the
Debris Filter over the Metal Tube
(2) , re-tighten screw to
secure into place.
Fig 2.
NOTE: Leave a small distance between the end of the
Debris Filter and Metal Tube.
IMPORTANT:
We recommend that the Fabric
Filter and HEPA Filter are removed and washed
every
2-3 uses.
To power on the Ash Vacuum, press the ON/OFF Switch
(7) located on the top of the Main Unit (6).
To power off, press the ON/OFF Switch to the off position.
CAUTION: Always ensure that both the Fabric Filter (4)
and the HEPA Filter (5) are in place before operating the
Ash Vacuum.
WARNING! Never vacuum hot embers. Always ensure
that the ashes have been left too cool for approximately
four days. Always use metal fireplace tools to sift the ash
to check for embers.
CAUTION: Ensure the outside of the Flexible Hose does
not come into contact with any hot surfaces. Although the
centre is lined with a metal lining, the outer is plastic and
this could cause damage.
USAGE
REMOVING THE FILTERS
The Ash Vacuum has 2 filters: a Fabric Filter (4)
located inside the Main Unit, and a HEPA Filter (5)
attached to the lid of the Main Unit.
3
To access the Filters, remove the lid by unclipping
both Release Clips
(8)
located on the sides of the
Main Unit (6). To release the catch, lift up the handle
on the bottom of the Release Clips.
Loosen
Tighten
Fig 1. Fig 2.