4
9
Align Plastic Template to Mark and Prepare Door, if
Required.
8
With Door Laying Flat, Draw Horizontal and Vertical
Device Center Lines ( ).
RHR shown
(LHR opposite)
NOTE:
Centerlines
predetermined by cutout.
If no cutout exists, refer
to Step 10 to determine
centerlines.
!
2
¹⁄₂
"
Backset
Plastic
Template
NOTE:
This hole is to be
¹⁄₂
"
diameter (disregard larger center
hole of plastic template).
!
For 2-Point Latch Only
7
Disconnect Bottom Latch Cable Assembly from
Center Slide.
A cable removal tool has been
provided. Slot in tool fits over
cable, holding tabs down
Disconnect cable end
from cable link
Remove bottom latch
cable assembly from
center slide.
Pull on cable snap to
loosen cable for
removal
a
b
d
c
