50A
IMG-216823
50B
IMG-216824
Connecting the power supply cable
Illustration A
Take the power supply cable (A in the kit illustration) from the kit.
Connect the power supply cable to the suppression cable (B) as
illustrated.
Note!
The smaller grey connector (female) on cable A, must be
plugged into the larger connector (male) on the suppression
cable B.
Connectors:
to the subwoofer (1)
to the pre-routed single pole connector (2)
to the connector detached from the amplifier (3)
to the amplifier (4)
Illustration B
Note!
The previously installed fibre optic cable is not illustrated.
Plug connector (1) into the rear end face of the subwoofer.
Plug the connector (2) into the pre-routed black connector (5)
which is taped on the cable harness at the rear edge of the left-
hand rear wheel arch.
Detach the existing connector in the amplifier and plug it into
connector (3) in the T-cable
Plug the remaining connector (4) in the suppression cable to the
amplifier.
Tape and clamp the relay (6) and all loose connectors in at the
car's existing cable harness to prevent rattling.
Applies to cars with RTI: Temporarily detach the fibre optic cable
to the GPS antenna to improve access.
Installation instructions, accessories
Volvo Car Corporation Gothenburg, Sweden
© Volvo Car Corporation
Subwoofer- 30752136 - V1.1
Page 30 / 33
