Volvo Penta AQ205, Руководство оператора

Страница: 7 / 29

5
4 5 6 7 8
9 13 12 11 10
Release the speed control from the gear function
as follows: Press the release button (1) while the
lever (2) is in neutral and then press the lever
slightly forward. Let go of the release button. The
lever will now only affect the speed control.
Turn the starter key one step to the right. Then
press it in and turn it one more step to start the
engine. Release the key as soon as the engine
starts.
Check immediately after starting that the instru-
ments for oil pressure and battery charging dis-
play normal readings. In the event of abnormal
readings, stop the engine immediately and inves-
tigate the cause.
Run the engine until it is warm at a fast idling
speed, i.e. at a speed between 900–1200 rpm.
The boat is ready for use when the needle of the
temperature gauge reaches the green area.
Reduce the engine speed to idling and check that
the engine runs smoothly. Pull back the control
level to the neutral position. The control level is
now linked to the gear function (this applies to
Volvo Penta controls).
RUNNING INSTRUCTIONS
The single control lever operates both the speed
and the power transmission.
F = Forwards
R = Reverse
N = Neutral
T = Throttle
To obtain good operating economy, the engine
should not be run at maximum speed for long pe-
riods.
While the engine is running, check that the en-
gine temperature is normal (within the green area)
and that the instruments for battery charging and
oil pressure display normal values. If the values
are abnormal, stop the engine immediately and
investigate the cause.
The outboard drive can be trimmed in and out hy-
draulically while in operation. To lower the bow of
the boat, one of the switches (1), (in the control
or on the instrument panel) shall be kept in the up
position until the required attitude is reached. To
raise the bow, switch (1) shall be kept in the low-
er position.
Caution! The two switches (1) must never be
used simultaneously.
WARNING! Exercise extreme care when
running with the drive in the fully extended
position.
The Aquamatic drive can be trimmed within the
trim limit range to give the boat the best attitude.
In the case of the SP drive, the maximum trim
angle corresponds to 12 on the trim gauge and for
the DP 6.
4
5
6
7
8
9
10
11
12
13