4. Important Safety Warning (SAVE THESE INSTRUCTIONS)
CAUTION!
To prevent the risk of fire or electric shock, install in a temperature and humidity
controlled indoor area free of conductive contaminants. (See the specifications for the
acceptable temperature and humidity range.)
CAUTION!
To reduce the risk of overheating the UPS, do not cover the UPS' cooling vents and
avoid exposing the unit to direct sunlight or installing the unit near heat emitting appliances
such as space heaters or furnaces.
CAUTION!
Do not allow liquids or any foreign object to enter the UPS. Do not place beverages
or any other liquid-containing vessels on or near the unit.
CAUTION!
In the event of an emergency, press the OFF button and disconnect the power
cord from the AC power supply to properly disable the UPS.
CAUTION!
Do not attach a power strip or surge suppressor to the UPS.
CAUTION!
If the UPS is with metal chassis, for safety purpose, grounding is a must during
UPS installation in order to reduce leakage current below 3.5mA.
CAUTION!
Servicing of batteries should be performed or supervised by personnel
knowledgeable of batteries and the required precautions. Keep unauthorized personnel away
from batteries.
CAUTION!
When replacing the batteries, use the same number and type of batteries.
CAUTION!
Internal battery voltage is 12VDC. Sealed, lead-acid, 6-cell battery.
CAUTION!
Do not dispose of batteries in a fire. The battery may explode. Do not open or
mutilate the battery or batteries. Released electrolyte is harmful to the skin and eyes.
CAUTION!
Unplug the UPS prior to cleaning and do not use liquid or spray detergent.
CAUTION!
A battery can present a risk of electric shock and high short circuit current. The
following precaution should be observed before replacing batteries:
1)
Remove watches, rings, or other metal objects.
2)
Use tools with insulated handles.
3)
Wear rubber gloves and boots.
4)
Do not lay tools or metal parts on top of batteries.
5)
Disconnect charging source prior to connecting or disconnecting batteries terminal.
5. Trouble Shooting
Use the table below to solve minor problems.
Problem
Possible Cause
Solutions
No LED display on the
front panel,
Low battery.
Charge battery at least 6 hours.
Battery fault.
Replace with the same type of
battery.
UPS is not turn on
Press the power switch again
Alarm continuously
sounds when the
mains is normal.
UPS is overload.
Remove some loads first. Before
reconnecting equipment, please
verify that the load matches the UPS
capability specified in the specs.
UPS fault.
Return the unit to service center.
Mains normal but
yellow LED is flashing.
Power cord is loose
Reconnect the power cord properly.
6. Specifications
Model
Bonnie-50
CAPACITY
50W
INPUT
Voltage
220 VAC
Voltage Range
160-280 VAC
OUTPUT
Voltage
Dual outputs: 12VDC and 12VDC
Voltage Regulation
10V – 13.7V
Transfer Time
0 ms
EFFICIENCY
AC Mode
70% at nominal voltage (battery fully charged)
Battery Mode
>90%
BATTERY
Type & Number
12V/9Ah x 1
Charging Voltage
13.7 V ± 0.25 V
Charging
Current
At no load
3 A @ nominal voltage
At full load
0.7 A @ nominal voltage
Charging Time
4-6 hours recover to 90% capacity
PHYSICAL
Dimension (DxWxH)
228 x 82.5 x 207 mm
Net Weight (kgs)
3
Environment
Humidity
0-90 % RH @ 0-40
°
C (non-condensing)