3) Choose a suitable mounting location in the ceiling. Centre of room is ideal. If not, at least
250mm from a wall. The fan is intended to be mounted at high level and must be installed so
that the blades are more than 2.1m above the floor.
4) CAUTION: Ensure that the intended hole will have suitable room to locate the unit and that it
will not interfere with joists or the ceiling structure. Joists, beams and rafters shall not be cut
or notched to install the appliance.
5) There must be adequate clearances. Make sure a minimum of 250mm is maintained between
the appliance and any wall. There should be a minimum of 300 mm height clearance in the
ceiling (including any objects above the housing). A minimum of 30mm clearance is
required around the hole for the fan, the vertical sides of the appliance and any adjoining
parts of the roof structure, such as joists or insulation batts.
6) Use the template card provided as a hole cutting template to mark out the intended hole
(Ø300mm) for mounting the appliance (it may be safer to mark the position from above the
ceiling where obstructions are clearly visible, rather than from inside the room).
7) Carefully cut around the line. We recommend using the Voltex adjustable hole cutter.
8) Remove the fascia of the exhaust fan by releasing the two fascia springs, and disconnecting
the LED plug by pulling apart.
9) In compliance with AS/NZS wiring rules, wire the unit as shown in the figure below:
10) Turn all mounting clips toward the centre of the exhaust fan.
11) Insert the fan into the hole. Using a screwdriver, tighten the screws of the mounting clips in a
clockwise direction to lock the clips and exhaust fan in place to the ceiling.
12) Connect the ducting, keeping the ducting as straight as possible to maximise the
performance of the fan. If necessary seal and secure the join with duct tape.
13) Reconnect the LED plug, and replace the fascia back on to the exhaust fan body using the
fascia springs.
14) Your installation is now complete.
15) To select LED colour: with the LED light on, perform a fast OFF-ON switch action.
© Voltex Electrical 2019. All Rights Reserved.
®
= 300mm
C
M
E
N
E
Light
Fan (Exhaust)
W: Wall switch(s)
K
N
A
W
M: Motor
C: Capacitor
K: All-pole disconnection switch
Exhaust
Light
L: LED Driver & Light
L
