© Voltex Electrical 2016. All Rights Reserved.
®
A few minutes planning can make a big difference to the installation time and to your
satisfaction with the function of the appliance.
1.
For the exhaust fan to work efficiently, replacement air of a volume equivalent
to what is being extracted must be able to enter the room. In general, this
air would be drawn under the door, or through a slightly open window. If the
room is airtight, the fan will function poorly.
2.
LED lighting of the appliance is designed to provide directional lighting only.
While it may be sufficient for most common tasks, others such as shaving or
applying make-up may require additional lighting.
3.
This appliance is designed for installation in flat ceilings ONLY. Do not mount
it on a sloping ceiling or a vertical wall.
4.
Before commencing any cutting, check that there are no obstructions
such as ceiling joists and that there is sufficient height clearance for the
housing and routing of the duct. Check that the electrical wiring can be
routed from the wall switches to the mounting location.
IMPORTANT CONSIDERATIONS BEFORE INSTALLING
7.
This appliance is designed for indoor use only.
8.
Do not allow any foreign object to enter through the facia opening or the rear
of the appliance as this may damage the appliance and/or the user.
9.
The appliance shall, under no circumstances, be covered with insulating
material or similar material.
10.
Make sure that the power is OFF before installation.
11.
When cutting into the mounting surface, do not damage electrical wiring
and other hidden utilities.
12.
The appliance must be properly connected to the protective earthing
conductor in the fixed wiring of the installation.
13.
Precautions must be taken to avoid the back-flow of gases into the room
from the open flue of gas or other fuel-burning appliances.
14.
FOR SAFE USE OF THIS APPLIANCE, AFTER INSTALLATION, DISCONNECTION
OF THE APPLIANCE FROM THE SUPPLY SHALL BE POSSIBLE. THIS MAY BE
ACHIEVED BY HAVING THE PLUG ACCESSIBLE OR MEANS FOR ALL POLE
DISCONNECTION MUST BE INCORPORATED IN THE FIXED WIRING IN
ACCORDANCE WITH THE WIRING RULES.
