INSTALLATION INSTRUCTIONS
w w w . v o l t l i g h t i n g . c o m
- 4 -
VOLT
®
Plastic Solar Deck Light
VSDL-6012-PBK
Install Mounting Bracket
2
Test Solar Light
1
1
2
Press the ON/OFF switch on
the back of the fixture body.
Place the solar light on a
non-abrasive surface with
the solar panel against the
surface to test the fixture.
There will be a short delay
for the fixture to light up.
The fixture will light up when
the solar panel is covered
and turn back off when it is
uncovered.
Now you can proceed to next
steps of installations knowing
the fixture is in ON mode.
On/Off Switch
Fixture Body
Non-abrasive Surface
1. Place the mounting bracket onto
the desired location and mark two
points on the wall for the wall
anchors.
2. Remove the mounting bracket.
Drill the proper holes on the marks
for the wall anchors by using an
electrical drill.
3. Push the wall anchors into the
drilled holes.
4. Attach the mounting bracket onto
the wall anchors and secure with
the screws. Tighten until snug with
a screwdriver.
W
ALL SURF
ACE
Mounting
Bracket
Screw
Wall Anchor
Hole
NOTE: These deck lights need to be mounted in a place where
there is plenty of sunlight.
