background image

HS 7 & HS 11 

3.

 

Plug power cord into grounded electrical outlet with the nameplate rated voltage.  

  

 

WARNING 

BURN HAZARD 

Hot water and steam in the well can burn skin.   

Use protective gloves, mitts or potholders when removing food containers or covers.  

 Hot food can also cause burns.  Handle hot food carefully.

 

 
4.

 

For the operation of: 

Holding hot  food at the proper serving temperature 

1.

 

Preheat the water in the well by covering well with an empty food container or 
cover, and then set the heat control to the maximum heat setting.  

Preheat for 

20 minutes

  

2.

 

Place container of hot food product into preheated food merchandiser. Set heat 
control knob to “7” Adjust as needed while monitoring food temperatures 
closely for food safety. (See food safety precautionary note below)  

3.

 

Maintain water level at or near water level mark. Periodically (approximately 
2 hours) remove container of food and check the water level. Add hot water if 
needed. 

 

Rethermalizing refrigerated food that has been previously cooked 

1.

 

Preheat the water in the well by covering well with an empty food container or 
cover, and then set the heat control to the maximum heat setting.  

Preheat for 

30 minutes. 

2.

 

Place stainless steel container of cold food into the well. 

Maintain maximum 

heat setting.

 

3.

 

During the rethermalization process, monitor food temperatures closely for 
food safety.  The United States Public Health Service recommends that the 
entire food product reaches and maintains a minimum of 165

F (74

C) for at 

least 15 seconds to be properly rethermalized.  In addition, rethermalized food 
must pass through the danger zone of 41

F (5

C) to 165

F  (74

C) in less than 

2 hours to prevent growth of organisms of public health concern. 

Do not add 

cold food for rethermalizing while holding hot food; the merchandiser 
will cool down and not hold the hot food at proper serving temperature. 

To reach the required safe food temperature as quickly as possible, do not add 
water or remove food pan during the rethermalization process. 

 

 

5.

 

Reduce heat setting to a level that will maintain a safe holding temperature and maintain food 
quality. (See Food Safety Precautionary Note) 

 

FOOD SAFETY PRECAUTIONARY NOTE 

 

Monitor food temperatures closely for food safety.  The United States Public Health 
Service recommends that food be held at a minimum of 140

F (60

C) to help prevent 

bacteria growth 
 

Содержание Cayenne HS-7






Отзывы: