C
ayenne
® H
eavy
-D
uty
I
nDuCtIon
R
anges
O
peratOr
’
s
M
anual
4
Adjusting the Power and Temperature
1. Press the on/off button (A) to turn on the hob on. See Figure 2. The on
led (B) will illuminate. When induction-ready cookware is placed on the
range, the display will remain “steady on” with a value. This indicates
the unit is heating. Models with two heating surfaces will have separate
ON/OFF buttons for each heating surface.
2. Press the power/temp button (C) to choose a cooking power level
(1 – 100) or an approximate temperature (100° – 400° F). The power
led light (D) will illuminate when the unit is in the power mode. The
temperature light (E) will illuminate when the unit is in the temperature
mode.
3. Press the up button (G) or the down button (H) to increase or decrease
the power level or temperature.
Activating the Timer
1.
Press the timer button (I). The display will show “1” with a flashing dot
in the lower right corner.
2. Press the up button (G) or the down button (H) to set the timer from 1
to 180 minutes.
3. When the timer cycle is complete, the unit will turn off.
4. To cancel the timer, press the power/temp button (B). The timer will turn
off and the unit will return to the power or temperature mode.
c
leaning
To maintain the appearance and increase the service life, clean your
induction range daily.
WARNING
Electrical Shock Hazard.
Keep water and other liquids from entering the
inside of the unit. Liquid inside the unit could cause
an electrical shock.
If liquid spills or boils over onto the unit, immediately unplug the unit
and remove cookware. Wipe up any liquid with a padded cloth.
WARNING
Burn Hazard.
Do not touch cookware, heating surface, food, or
liquid while heating.
Hot food and liquids can burn skin. Induction heating surfaces heat
very rapidly. Use caution when adding pre-heated oil, liquid or other
food already in the cookware.
1. Unplug the unit and let it completely cool.
2. Wipe the unit exterior with a clean damp cloth.
3. Do not use abrasive materials, scratching cleansers or souring pad to
clean the unit. These can damage the finish.
4. Thoroughly wipe off any mild soap or chemical cleaners. Residue
could corrode the surface of the unit.
