ACTIVATION METHOD
The product uses a food grade SPE film electrolysis principle. When used for the first time, there are fewer bubbles, and the SPE
film needs to be activated to ensure that the hydrogen content of the rich hydrogen is maximized.
Activation method
1.
Natural slow activation after normal use.
2.
With hot water (water temperature of 80 °C or less recommended electrolysis can speed up the activation process.
NOTE:
In order to make hydrogen work well, water should always be kept in the glass cup to avoid drying out the SPE film.
OPERATION
No Assembly Required.
Unit needs to be fully charged before use.
1. Remove cap and base rinse glass bottle in clean water but do not use detergent.
NOTE:
Do not wash the switch or charge port.
2. Fill bottle with potable water, replace cap.
NOTE:
Cold water is recommended. The warmer the water temperature, the less hydrogen produced.
Power Button Operation
1. Press the round power button. The blue light comes on.
2. It’s now producing hydrogen.
NOTE:
During working process, if the light flashes, you need to charge the bottle. It displays red light when charging, and
green light when fully charge.
Charging
1. Open the rubber charge port cover to connect the small charging cable to the unit connection.
2. Connect the other end of the charger cable to an appropriate power source.
3. Plug the power adapter into an appropriate power source. When charging, a red light is displayed and turns off when the
charging is completed.
4. When fully charged, a green light is displayed.
NOTE:
Use the remaining electricity before re-charging, so as to better activate the lithium battery. It takes 3.5 hours to full
charge lithium battery.
Water Quality Requirements:
Drinkable drinking water, such as purified water and mineral water. The use of juices, beverages,
tea, alcohol, coffee, and other solutions is prohibited.
Power Reminder:
When the power is insufficient, there will be a flashing light prompt. At this time, you need to charge in time.
If you continue to consume power, the device will not start and there will be no flashing light prompt. Insufficient power and no
charge for a long time will cause permanent damage to the lithium battery.