OR:
— Remove the spare key → page 73.
— If necessary, remove the cover of the driv-
— Press the button on the vehicle key.
— Unlock the vehicle using the spare key.
— Open the driver door. If the vehicle has an
anti-theft alarm, this will be triggered im-
— Switch on the ignition.
Please note
: to
switch on the ignition, place the vehicle
key in the drink holder or the stowage
compartment in the centre console
→ page 139.
The synchronisation process is complete.
Troubleshooting
Vehicle cannot be locked or unlocked
The remote control is subject to interference
caused by obstacles, adverse weather condi-
tions or other transmitters operating in the
same frequency range in the vicinity of the
vehicle, e.g. mobile devices, or due to a weak
or flat button cell.
OR: the central locking system has switched
itself off temporarily to protect itself against
overloading.
— Close the driver door.
— OR: synchronise the vehicle key
— OR: change the button cell in the vehicle
Indicator lamp does not flash
If the indicator lamp in the vehicle key does
not flash when pressing the button, the but-
ton cell in the vehicle key has to be replaced
Additional or replacement vehicle keys
can be obtained from a Volkswagen
dealership.
Keyless locking and start-
ing system “Keyless Ac-
cess”
Introduction to the topic
The Keyless Access function allows the vehi-
cle to be unlocked and locked without active-
ly using the vehicle key. For this purpose,
a valid vehicle key must be within close range
of the vehicle.
Unlocking or locking the vehi-
cle with Keyless Access
Fig. 57 In the door handle: sensors.
Fig. 58 Keyless Access: operating ranges.
Configuring Keyless Access
The behaviour of the keyless access locking
and starting system Keyless Access can be
Keyless locking and starting system “Keyless Access”
75
11A012720AB