VolantexRC Racent Claymore Series, Руководство пользователя

Страница: 7 / 8

7 / 8 CLAYMORE SPEED BOAT
Boat does not respond
to throttle but responds
to other controls
Throttle servo travel is lower than
100%
Make sure throttle servo travel is 100% or
greater
Throttle channel is reversed Reverse throttle channel on transmitter
Extra noise or extra
vibration
Damaged propeller, shaft or motor Replace damaged parts
Propeller is out of balance Balance or replace propeller
Reduced runtime or
boat underpowered
Boat battery charge is low Completely recharge battery
Boat battery is damaged
Replace boat battery and follow battery
instructions
Blocking or friction on shaft or
propeller
Disassemble, lubricate and correctly align
parts
Boat conditions may be too cold Make sure battery is warm before use
Battery capacity may be too low
for conditions
Replace battery or use a larger capacity
battery
Drive dog is too close
Loosen coupling at shaft and move away
shaft a small amount
Too little lubrication on shaft Fully lubricate shaft
Vegetation or other obstacles block
the rudder or propeller
Remove boat from the water and obstacles
Boat does not bind
(during binding) to
transmitter
Transmitter is too near boat during
binding process
Move powered transmi tter a few feet from
boat, disconnect and reconnect battery to
boat
Boat or transmitter is too close to large
metal object
Move boat or transmitter away from large
metal object
Bind plug is not installed correctly Install bind plug and bind boat to transmitter
Boat battery/ Transmitter battery
charge is too low
Replace/recharge batteries
ESC switch is off Power on ESC switch
Boat does not link (after
binding) to transmitter
Transmitter is too near boat during
linking process
Move powered transmitter a few feet from
boat, disconnect and reconnect battery to
boat
Boat or transmitter is too close to large
metal object
Move boat or transmitter away from large
metal object
Bind plug is left installed
Rebind transmitter to boat and remove bind
plug before cycling power
Boat battery/transmitter battery
charge is too low
Replace/recharge batteries
Transmitter may have been bound to
a different model (using different DSM
Protocol)
Bind boat to transmitter
ESC switch is off Power on ESC switch
Boat tends to dive in
water or takes on water
The boat hull is not completely closed
Dry out the boat and ensure the hatch is
fully closed on the hull before re turning the
boat to the water
Center of gravity is too far forward Move batteries back in the hull
Trim tabs are angled incorrectly on
the back of the boat
Angle each trim tab up a small amount to
lift the bow or down a small amount to lower
the bow