Brake Function Setting
BRAKE FUNCTION: The factory default brake setting is “off”.
Skip to the “ESC OPERATION” section below if you want to
keep this setting.
To turn the brake “on”:
1. Move the throttle stick to full throttle, turn on the transmitter
and connect the battery to the ESC.
2. After 2 seconds the motor will have one beep sound , then
the ESC will be in the Programming mode.
3. When you hear 3 continue beep, it’s the break function setup.
This kind of sound will last circulate 4 times. During these 4
times, you can move the throttle stick to the off position. After
that the motor will have 1 beep sounds, means the ESC have
saved the setting.
4. Then you can unplug the battery to restart.
To turn the brake off, repeat the above process.Once the brake
is set, it does not require resetting after the ESC has been switched
off.
Working condition:
Brake “on”: When you pull off the throttle, the Propeller will
stop immediately.
Brake “off”: When you pull off the throttle, the Propeller will
stop naturally.
5
