Maintenance
Removing defective/broken stainless steel element
1
Disconnect unit from electrical supply.
2
Pour hot (not boiling) water containing washing-up liquid (not boiling) into unit to soften plastics
prior to removal.
3
Grip stainless steel tube, twist to break seal and carefully push out element.
4 DO NOT PULL FROM EXTERNAL CONTROL BOX.
To fit new stainless steel element
1
Place seal into cup or bowl and pour on hot (not boiling) water to soften seal.
2
Place the warm seal in locating hole with extended side uppermost. Lubricate stainless steel tube
with washing-up liquid or similar and push into position. Ensure control box is upright before inser-
tion with the cable uppermost on the right-hand side.
3
Carefully re-fit sucker support to the end of the stainless steel tube. DO THIS WHILST SEAL IS
WARM AND SOFT.
4
DO NOT soften or distort the wall of the warming bucket when re-inserting the replacement element.
5
The controller is fitted with an electrical cut-out, which will activate if the unit is used without water
in the bucket. If it cuts out the unit should be switched off for 10 minutes, then the bucket filled with
water and switched on again. The unit will have reset itself. If you still have no power, check the fuse
and if still faulty, consult your electrician.
Lamb Volostrum
®
A natural alternative to colostrum.
Volac Lamb Volostrum’s guaranteed high level of proteins and oil supply a readily available source of
nutrients and energy to help get the lamb off to a good start in life and guard against hypothermia.
Typical Analysis
Easy Mixing
Vital Energy Boost
100% Natural
To watch a video on how to mix
visit ww.volac.com/Lambvolostrum
