Voice-Acoustic Aleasub-10, Руководство пользователя

Страница: 8 / 10

Page 8 of 10 Manual Aleasub-10 - 2018-07 EN
Working with Aleasub-10
Mounting the U-bracket
1. Remove the M10 countersunk screws (A) on both sides of the
subwoofer.
2. Use the supplied M10 knurled screws (B) including plastic was-
hers to mount the U-bracket.
3. To protect the coatings, place the plastic discs between the
knurled screw, U-bracket and subwoofer.
The U-bracket can be used to install the subwoofer on ceilings. The
four rubber feet are not screwed on, only included.
Mounting wall holder for hidden mounting
To install the subwoofer flat on the wall, you must use the 4-pin
Phoenix Contact connector in the recessed connector panel.
1. Mount the wall holder at the desired location using the appro-
priate fixing material. The side with the two M4 x 20 mm grub
screws (C) points upwards!
2.
Note: The loudspeaker cables must be led out of the wall in the
area of the recessed connection field!
Connect the subwoofer via the Phoenix Contact.
3. Hang the subwoofer into the two grub screws.
4. Turn the lower grub screw (D) out through the small opening at
the bottom until it is flush with the edge of the housing.
Folding handle mounting
1.
Remove the five M6 x 12 mm cylinder head screws from the
rear panel.
2. Use the five cylinder head screws to mount the folding handle
to the rear of the subwoofer (E).
A
B
C
D
E