Vogue L927, Руководство по сборке, Страница: 3 / 16

2
Assembly
1.
Screw the upper poles to the lower poles. Ensure the poles are securely screwed together.
2.
Select the required height for the bottom shelf. Shelves can be attached at any of the circular grooves,
spaced 25mm (1”) apart, along the pole.
3.
Attach the sleeve to the pole at the required position
[Fig. 1
].
4.
Holding the shelf on its side, slide the pole through one of the corner holes
[Fig. 2]
.
5.
Once all four poles are through the corner holes stand the shelving unit upright, and press the bottom
shelf firmly onto the sleeves
[Fig. 3]
.
6.
Locate the next shelf by counting grooves on the pole to the desired height. Attach a pole sleeve and
repeat for each pole
[Fig. 4]
.
7.
Lift the shelf up and onto the four poles, sliding the shelf down upon the sleeves.
8.
Repeat steps 6 and 7 for the next two shelves.
9.
If necessary, adjust the feet on the bottom of each pole to level the shelving unit.
All rights reserved. No part of these instructions may be produced or transmitted in any form or by any means, electronic,
mechanical, photocopying, recording or otherwise, without the prior written permission of VOGUE.
Every effort is made to ensure all details are correct at the time of going to press, however, VOGUE reserve the right to
change specifications without notice.
Note: The upper poles have black plastic caps at one end and a thread at the other.
Note: The bottom shelf should never be more than 300mm (12”) from the floor. Shelves
should never be situated more than 450mm (36”) apart.
Grooves
Small end up
Slipsleeve
Large end down
Corner hole
Wire on top
Fig. 1
Fig. 2 Fig. 4
Fig. 3
EN