REAR PANEL HOOKUP
(CONTINUED)
Insert: To use the Insert effectively you will need an insert cable. The insert cable or “Y” adaptor, as it is sometimes referred to as,
typically has a stereo 1/4” “phone” jack on one end and two mono RCA jacks or 1/4” jacks on the other. Most adaptors of this type are
available at electronics stores, such as Radio Shack. Connect the stereo 1/4” phone jack to the Insert jack on the KJ-8000 Pro then connect
the two “mono” ends to the signal jacks on you external effects unit (see your owners manual). Once your external effects unit is properly
connected to the KJ-8000 Pro, you will be able to adjust the incoming signal from your external effects unit (as described your users
manual). In some cases you may receive high frequency “noise” from an external effects unit. In this case, you can adjust some of the
“noise” out by using the high frequency channel “EQ” fader.
Microphone Section
Mic: The Mic connector jacks can be used to connect a high or low impedance microphone or an instrument.
Connecting Turntables or Other Players
The Line and Phono jacks, located in the stereo control section (see above), are designed to connect turntables or additional players. If you
are connecting a turntable be sure to connect it to the Phono L and R jacks. These jacks have a lower signal output and are designed
specifically to connect turntables. Be sure to set the toggle switch on the face of the board to PHONO otherwise there will be no sound
output. Additional players can be connected to the Line input jacks, however, the line inputs have no video switching capability. These
jacks are designed for use with tape decks, for example, that will not require a video input jack. If you are using a player with video output,
and wish to use the video input you must use the corresponding CD(1), LD(2), or DVD(3) input jacks, as they correspond to video input
jacks 1,2 and 3. The video output jacks are located in the stereo/music section as well.
“XLR” Connector: Use the “XLR” connector for your low impedance microphone and cable.
Note: The “1/4”/ MIC” and “XLR” inputs on the same channel will not work at the same time. A microphone
connected to the “XLR” input will cancel out anything connected to the 1/4”/ MIC input.
3
Master Control Section
Stereo/Music Control Section
Microphone Control Section
Expandability Module
(optional)
(Empty)
Locate the Sub Bass section of the Master control section on the back of the KJ-8000 Pro Use Out 1 and or Out 2 to connect your external
(powered) sub woofer. Use the Frequency control to select the crossover point, between 50Hz and 200Hz, for the sub-bass section. All
frequencies below the crossover point are output through Out 1 and Out 2.
Connecting a Sub Woofer
