6
WR-1 REAR VIEW
Device ID
The rotary ID switches are located on the rear of the WR-1 and give the unit a unique Device ID. The switches are in hexadecimal format.
All WR-1 units must have a unique Device ID to function properly within a Vocia Paging World (i.e., it is not possible to have two WR-1 units
with the same Device ID of hex 07). To assign a Device ID of hex 07, turn the LSB switch to 7 and leave the MSB switch on 0. To create
an ID of hex B7, turn the LSB switch to 7 and turn the MSB switch to B. Device ID switches should be set using a 0.1 inch (2.5mm) to
0.12 inch (3.0mm) flat blade screwdriver. More information on setting IDs and the hexadecimal numbering scheme used in Vocia can be
found in the Vocia Help File.
Please note: Changes made to the Device ID while connected to the network require a power cycle in order to take effect.
Network Connection
The WR-1 has one RJ45 connector that should be wired to shielded CAT5, CAT5e, CAT6, or CAT7 cable cabling to interface the WR-1
to a Vocia system via a PoE-compliant network switch. The RJ45 connector provides two LEDs that indicate Ethernet link and network activity
(see table below).
Left LED
Right LED
Description
None
None
No power or data connectivity. Please check the PoE network connection.
Green
None
Link established.
Green
Flashing
amber
Link established and CobraNet activity detected; the unit is acting as a CobraNet performer.
Flashing
green
Flashing
amber
Link established and CobraNet activity detected; the unit is operating as a CobraNet conductor.
Flashing
amber
Flashing
amber
CobraNet fault. Check cabling and configuration for errors.
Network
Connection
Device ID