11
Initial operation:
Open the
battery compartment cover.
Insert 2 x AA batteries observing polarity [ “+” and “ –“ marks].
When you insert the batteries, all the icon on the LCD will light up for 5 seconds, and then detect indoor temperature &
humidity.
The receiver will now start to make a connection to the outdoor remote sensor. This operation takes about 3 minutes and is
displayed by a flashing reception RF antenna symbol on the receiver.
This now, Open the remote Sensor
battery compartment cover, Insert 2 x AAA batteries observing polarity [ “+” and “–
“ marks]
After receiver has created a connection to the outdoor remote sensor, After 3 minutes it will Exit RF mode.
°C/°F temperature display:
The temperature is displayed either in °C/°F. Briefly pressing the
“
℃
/
℉
”
button allows you to switch between the individual
modes.
Query Maximum/minimum numerical value:
When the indoor/outdoor temperature/humidity are shown in the LCD, The receiver began to record temperature/humidity
maximum and minimum numerical value.
Press once
“
MEM
”
button, the LCD will display maximum value of temperature/ humidity, The LCD will display the minimum
value of temperature/humidity if press once
“
MEM
”
button again when the maximum value is displayed.
At the same time, there are “MAX” or “MIN” displayed on the LCD.
The memory value of the day will be automatically cleared at 0:00 every night.
Press and hold the
“CLEAR”
button for 2 seconds, the temperature/humidity maximum and minimum numerical value will be
cleared.
F.Y.I.:
If the temperature reading is below ranges, the
“
LL.L
”
will be displayed. If the temperature reading is above ranges, the
“
HH.H
”
will be displayed.
RF Transmission Procedure:
The receiver automatically starts receiving transmission from outdoor remote sensor for outdoor temperature & humidity
after batteries inserted.
The remote sensor will automatically transmit temperature and humidity data to the receiver after batteries inserted.
If the Receiver failed to receive transmission from outdoor remote sensor (“
- -.-
”display on the LCD),
Press the
“CH”
button to
select the channel, the number of selected channels will flash, then press and hold the
“CH”
button for 3 seconds, RF icon
will be flashing
,
the Receiver will rescan the launch signal of the channel.
Comfort level :
The temperature and humidity is dry (When the humidity is below 40%.)
The temperature and humidity is comfort (When the temperature in 20~28
℃
and the humidity in 40~70%)
The temperature and humidity is wet (When the humidity is above 70%)
F.Y.I.:
When the temperature is not in 20~28
℃
and the humidity in 40~70%, The comfort level icon will no display.
Displaying temperature/humidity and temperature/humidity trend:
The current indoor temperature/humidity and the temperature/humidity trend (indoors) are shown in the LCD display.