5
GRAPHITE 2
.
Assembling gide
ATTENTION!
Don't permit the glue to flow into the flap hinges or leave the glue stains on surfaces. Use the c
accelerator for faster gluing!
Before mounting the servos move the servo horns to the neutral position as shown at the picture 6.
ATTENTION!
After fixing the servos you can not screw out the servo horns. Regulate the horns to the
neutral position before gluing the servos into the wing.
Mount the servos into the wing by the special units for the Volz Micro Maxx servos mounting or glue
them with epoxy.
If gluing with epoxy pay attention to the moving parts isolation. Don't let the glue flow in between the
moving and fixed parts of the construction.
WARNING!
If your servos can't stand high loads you can face a controlling surfaces flatter, which
may cause your model crash.
Use only high quality servos for your model:
- MPX Micro Speed Digi or JR DS368 for the flaps
- MPX FL Digi or JR DS368 for the ailerons
pic. 7
After the epoxy polymerization regulate the length of the ailerons and flaps rods. Bend the flaps rods up
as shown at the picture 8, to avoid their touching the fixed parts when moving.
