ZUMA BREWER - OPERATION & SERVICE MANUAL
Page 4 of 8
0011
Zuma Brewer (N016352)
ZUMA BREWER SCREEN ASSEMBLY MAINTENANCE
Screen Assembly Extractor Tool
The screen assembly on the Zuma brewer can be very easily removed for cleaning or replacement
with a special screen extraction tool to properly do this. The part number of the Zuma Screen
Extractor Tool is
K023029.
Zuma Screen Extractor Tool
Removing the Brewer Screen Assembly
The following describes the correct procedure for removing the Zuma brewer screen assembly. It is
recommended you remove the brewer from the machine to remove the screen assembly. Once the
screen is removed, it should be thoroughly cleaned before it is re-installed.
1. Press the red <
LOAD FILTER TAPE
> button on the control panel to open the brewer.
2. Remove the brewer from the machine.
3. Remove the brew chamber assembly by lifting the latch bar and pulling the brew
chamber towards you.
4. Insert the Zuma screen extractor tool through the pour spout with the tip pointing
upwards (as illustrated in the diagram on the following page).
5. Gently push the extractor tool against the rear of the cylinder and slide it up until contact
is made with the screen assembly frame.
6. With the tool, push up on the bottom, rear center of the screen assembly to remove the
screen. Please note that some pressure will be required to pop the screen assembly
loose.
