seatback Installation (continued)
a. Place VizuaLogic seat foam onto factory seat
frame.
seatback Installation (continued)
2. Install VizuaLogic Seat foam and factory upholstery.
b. Route the round connector of the video cable
up into the back of the seat foam and out of the
plastic bucket in the foam.
c. Use tie-wraps to secure the cable at key points
along the seat frame in the foam bucket.
d. Install Upholstery Trim Template into bucket
using small amount of tape to secure in
opening.
e. Place the “inside-out” upholstery over the
“headrest” portion of the seat foam and install
(3) hog rings through the upholstery tab and
around the listing wire in the seat foam.
f. Work the upholstery back down around the seat
foam ensuring the upholstery seams and panels
are properly located and smooth.
g. Press the front of the seat upholstery against
the Velcro strips to properly shape the
upholstery around the bolsters and finish the
smoothing process.
h. Connect the front and rear “J” clips at the
bottom of the seat foam.
i. Re-install the plastic panel inside the back of the
seat upholstery.
j. Re-connect the “J” clip to the seat frame by
reversing the instructions in 1a.
4
5
